Mazda CX-5 Service & Repair Manual: Awd Warning Light
Purpose, Function
-
Warns the driver of a AWD system malfunction.
Construction
-
The AWD warning light is built into the instrument cluster.
Operation
-
If the self-diagnostic function stores a DTC, the warning light illuminates to alert the driver of the malfunction. If system control is temporarily suspended due to the rear differential oil temperature becoming abnormally hot or similar cause, the warning light flashes to alert the driver.
-
The AWD CM controls the operation of the warning light.
Fail-safe
-
Function not equipped.
Awd Solenoid Inspection
1. Disconnect the negative battery cable.
2. Disconnect the AWD solenoid connector.
3. Measure resistance between AWD solenoid connector terminals A and B.
If the resistance is not wit ...
Coupling Component Calibration Data Writing
1. Connect the M-MDS to the DLC-2.
2. After the vehicle is identified, select the following items from the toolbox
of the M-MDS.
Select “Chassis”.
3. Then, select items from the ...
Other materials:
Rear Stabilizer Removal/Installation [Awd]
WARNING:
Verify that the rear crossmember is securely supported by a jack. If the
rear crossmember falls off, it can cause serious injury or death, and damage
to the vehicle.
CAUTION:
Performing the following procedures without first removing the rear ABS wheel-spee ...
Condenser Removal/Installation
1. Disconnect the negative battery cable..
2. Remove the following parts:
a. Trunk board.
b. Trunk end trim (LH).
c. Rear scuff plate (LH).
d. Trunk side trim (LH).
e. D-pillar trim (LH).
3. Disconnect the connector.
4. Remove the bolts.
5. Remove the condenser.
6. Install in ...
Sae Standards
In accordance with new regulations, SAE (Society of Automotive Engineers)
standard names and abbreviations are now used in this manual. The table below
lists the names and abbreviations that have been used in Mazda manuals up to
now and their SAE equivalents.
...
