Purpose, Function
Warns the driver of a AWD system malfunction.
Construction
The AWD warning light is built into the instrument cluster.

Operation
If the self-diagnostic function stores a DTC, the warning light illuminates to alert the driver of the malfunction. If system control is temporarily suspended due to the rear differential oil temperature becoming abnormally hot or similar cause, the warning light flashes to alert the driver.
The AWD CM controls the operation of the warning light.
Fail-safe
Function not equipped.
Automatic Transaxle Warning Light [Fw6 A EL, Fw6 Ax EL]
Blind Spot Monitoring (Bsm) Off Indicator LightRefrigerant Pressure Sensor Inspection [Manual Air Conditioner]
1. Install the manifold gauge.
2. Verify the high-pressure side reading of the manifold gauge.
3. Measure the terminal voltage at PCM terminals 2BB, 2AX and 2AJ
4. Using the graph below, measure and verify the terminal voltage at 2AX.
5. Follow the PCM inspection when measuring the other ter ...
Adaptive Front Lighting System (Afs) Control Module Removal/Installation
NOTE:
The AFS control module prior to replacement stores the vehicle specification
information.
A new AFS control module does not store any vehicle specification information.
When the ignition is switched ON after the AFS control module is replaced,
the AFS control modu ...
Oil Seal (Side Gear) Replacement
1. Remove the drain plug and the drain differential oil into a container.
2. Install a new washer and the drain plug, and tighten.
3. Remove the rear drive shaft..
4. Remove the clip from the drive shaft.
CAUTION:
Wrap the end of a screwdriver with cloth to prevent scratches to the i ...