Chevrolet Spark manuals

Mazda CX-5 Service & Repair Manual: Automatic

Transaxle Range Sensor [Fw6 A EL, Fw6 Ax EL]
Purpose/Function The transaxle range sensor detects the position of the manual valve and selector lever. The transaxle range sensor signal is used for automatic shift control, manual ...

Automatic Transaxle Fluid (ATF) Adjustment [Fw6 A EL, Fw6 Ax EL]
CAUTION: Only adjust the ATF level when the ATF temperature is 45—55 °C {113—131 °F}. If the ATF level is incorrect, it could damage the transaxle. Do not add ATF over the spe ...

Other materials:

Rear Drive Shaft Removal/Installation
CAUTION: Performing the following procedures without first removing the ABS wheel?speed sensor may possibly cause an open circuit in the harness if it is pulled by mistake. Before performing the following procedures, remove the ABS wheel?speed sensor (wheel side) and fix it to an ap ...

Power Window System Initialization Procedure
NOTE: If the following operations have been performed, initial setting is reset, and auto up/down operation are disabled. Therefore, performing initial setting is necessary. Negative battery cable is disconnected.. Power window main switch connector is dis ...

Hood Latch Switch Inspection
1. Disconnect the negative battery cable.. 2. Remove the front bumper.. 3. Disconnect the hood latch switch connector.. 4. Verify that the continuity is as indicated in the table. NOTE: Inspect the continuity when the hood is open and closed. If the operation as i ...

© 2016-2026 Copyright www.mcx5.org