Mazda CX-5 Service & Repair Manual: Auto Dimming Mirror Removal/Installation
1. Disconnect the negative battery cable..
2. Remove the screw B.
3. Remove the auto-dimming mirror in the direction of arrow (1) shown in the figure.
4. Detach tabs while push the cover No.2 in the direction of the arrow (2) shown in the figure, then remove the cover No.2 in the direction of the arrow (3).
5. Disconnect the auto-dimming mirror connector.
6. Remove the auto-dimming mirror in the direction of arrow (4) from the mirror base.
7. Install in the reverse order of removal.
Auto Dimming Mirror Inspection
1. Measure the voltage at each terminal.
If the voltage is not as specified in the Terminal Voltage Table (Reference),
inspect the parts under “Inspection item (s)” and related wiring h ...
Filament Inspection
1. Switch the ignition ON (engine off).
2. Turn the rear window defroster switch on.
CAUTION:
Directly touching the rear window defroster filament with the lead of the
tester could ...
Other materials:
High Clutch [Fw6 A EL, Fw6 Ax EL]
Purpose/Function
The high clutch operates in 4GR, 5GR, and 6GR and intermittently operates
the rear carrier by drive force from the turbine shaft.
For the high clutch, a centrifugal balance clutch has been adopted to prevent
clutch drag and to assure stabilized piston thrust in ...
Catalytic Converter
Purpose, Function
Purifies contaminants in the exhaust gas by utilizing the chemical reactions
of the three-way catalytic converter.
A WU-TWC and a TWC have been adopted.
WU-TWC
The three-way catalyst is integrated with the exhaust manifold.
Because the c ...
Seat Warmer Control Unit Inspection
WARNING:
Handling a front seat (with built-in side air bag) improperly can accidentally
operate (deploy) the air bag, which may seriously injure you. Read the service
warnings/cautions before handling a front seat (with built-in side air bag)..
CAUTION:
After removing a f ...
