Removal
1. Insert a tape-wrapped flathead screwdriver into the service hole and remove the assist handle covers.
2. Remove the assist handle in the direction of the arrow (1) and (2), while detach clips.
NOTE:
Remove the assist handle by shaking it up and down.
Installation
1. Push the assist handle in the direction of the arrow shown in the figure.
2. Push the assist handle cover assembled to install the assist handle.
Spark Plug [Skyactiv G 2.0]
Purpose, Function
The spark plug generates spark, ignition of the air-fuel mixture occurs,
and combustion of the air-fuel mixture is triggered.
Construction
The spark plug is installed to the cylinder head.
Iridium on the center electrode and platinum on the ...
Rear Washer Hose Removal/Installation
1. Disconnect the negative battery cable..
2. Remove the front over fender..
3. Remove the mudguard (RH)..
4. Disconnect the rear washer hose A from the washer motor.
5. Remove the rear washer hose A from the washer tank hook.
6. Remove the rear washer hose A from clips A and B.
7. Disco ...
Solar Radiation Sensor Inspection [Full Auto Air Conditioner]
1. Shine a fluorescent light or expose the solar radiation sensor to natural
sunlight.
2. Connect the positive (+) lead to terminals B, C and negative (-) lead to terminal
A of the solar radiation sensor, and verify that the voltage value is output.
If the voltage is 0 V, replace ...