Mazda CX-5 Service & Repair Manual: Anticorrosion, Sound Insulation, And Vibration Insulation
Body Sealing
-
Apply body sealer where necessary.
-
For locations where application of body sealer is difficult after installation, apply it before installation.
Application of Undercoating
-
Apply an undercoat to the required location of the body.
Application of Rust Inhibitor
-
Apply rust inhibitor (wax, oil, etc.) to the back of the welded areas.
Application of Dumping Sheet
-
Apply dumping sheet by heating with an infrared ray lamp.
A Pillar Trim Removal/Installation
1. Partially peel back the seaming welt.
2. Take the shaded area shown in the figure, and pull the A-pillar trim in the
direction of the arrow (1) while detaching clip A, clips B.
3. Cut the ...
B Pillar Lower Trim Removal/Installation
1. Remove the front scuff plate..
2. Remove the rear scuff plate..
3. Partially peel back the seaming welt.
4. Take the shaded area shown in the figure, and pull the B-pillar lower trim
in the ...
Other materials:
Fuel System
Purpose, Outline
A multiple hole type fuel injector has been adopted which provides higher
fuel injection accuracy for improved fuel efficiency and output.
Piston movement-compression by the 4-head cam inside the high pressure fuel
pump heightens the fuel pressure, achieving imp ...
Condenser Removal/Installation
1. Disconnect the negative battery cable..
2. Discharge the refrigerant..
3. Remove the front under cover No.1..
4. Drain the engine coolant..
5. Remove the following parts:
a. Plug hole plate.
b. Air cleaner, air hose and fresh air duct component.
c. Coolant reserve tank.
d. Cooling ...
Engine Coolant
Inspecting Coolant Level
WARNING
Do not use a match or live flame in the engine compartment. DO NOT ADD COOLANT
WHEN THE ENGINE IS HOT:
A hot engine is dangerous. If the engine has been running, parts of the engine
compartment can become very hot. You could be burned.
Carefully inspect the e ...