Mazda CX-5 Service & Repair Manual: Antenna Feeder No.1 Removal/Installation
With audio system
1. Disconnect the negative battery cable..
2. Remove the following parts:
a. Side speaker grille (RH).
b. Tweeter (RH).
c. A-pillar trim.
d. Passenger-side front scuff plate.
e. Passenger-side front side trim.
f. Glove compartment.
g. Decoration panel.
h. Dashboard under cover.
i. Passenger-side lower panel.
j. Audio unit.
3. Remove clips A, B, C, D, E, and G.
4. Disconnect the SIRIUS satellite radio unit connector. (with SIRIUS satellite radio system)
5. Remove the clip F. (with SIRIUS satellite radio system)
6. Remove antenna feeder No.1.
7. Install in the reverse order of removal.
With car-navigation system
1. Disconnect the negative battery cable..
2. Remove the following parts:
a. Center speaker grille.
b. Front center speaker (with Bose®)/front center speaker dummy (without Bose®).
c. GPS antenna.
d. Side speaker grille (RH).
e. Tweeter (RH).
f. A-pillar trim.
g. Front scuff plate.
h. Front side trim.
i. Car-navigation unit.
j. Switch panel.
k. Decoration panel.
l. Shift lever knob (MTX).
m. Front console box.
n. Shift panel.
o. Upper panel.
p. Rear console.
q. Side wall.
r. Front console.
s. Hood release lever.
t. Driver-side lower panel.
u. Glove compartment.
v. Dashboard under cover.
w. Passenger-side lower panel.
x. Audio unit.
3. Remove clips A, B, C, D, E, F, H, I, J, K, and L.
4. Disconnect the SIRIUS satellite radio unit connector. (with SIRIUS satellite radio system)
5. Remove the clip G. (with SIRIUS satellite radio system)
6. Remove antenna feeder No.1.
7. Install in the reverse order of removal.
Antenna Feeder No.1 Inspection
With audio system
1. Disconnect the negative battery cable..
2. Remove the following parts:
a. A-pillar trim (RH).
b. Decoration panel.
c. Audio unit.
3. Disconnect antenna feeder No.2.
...
Antenna Feeder No.2 Inspection
1. Disconnect the negative battery cable..
2. Remove the following parts:
a. A-pillar trim (RH).
b. Trunk board.
c. Trunk end trim (RH).
d. Rear scuff plate (RH).
e. Trunk side trim (RH). ...
Other materials:
R 3 5 Brake [Fw6 A EL, Fw6 Ax EL]
Purpose/Function
The R-3-5 brake operates in 3GR, 5GR and in reverse to lock the reduction
internal gear against rotation.
Construction
The R-3-5 brake consists of the following parts shown in the figure.
The driven plate of the R-3-5 brake does not rotate be ...
Camshaft Position (CMP) Sensor Removal/Installation
CAUTION:
When replacing the CMP sensor, make sure there is no foreign material on
it such as metal shavings. If it is installed with foreign material, the sensor
output signal will malfunction resulting from fluctuation in magnetic flux and
cause a deterioration in engine control.
...
Refrigerant Pressure Sensor Removal/Installation [Manual Air Conditioner]
1. Disconnect the negative battery cable..
2. Discharge the refrigerant..
3. Disconnect the refrigerant pressure sensor connector.
CAUTION:
If moisture or foreign material enters the refrigeration cycle, cooling ability
will be lowered and abnormal noise will occur. Always immediate ...
