Purpose
The ambient temperature sensor detects the ambient temperature.
Function
The ambient temperature sensor converts the detected temperature to an electric signal.
Construction
A thermistor-type ambient temperature sensor has been adopted.
The ambient temperature sensor is installed to the shroud panel on the back side of the front bumper.
Operation
The thermistor changes the resistance according to the surrounding temperature.
The resistance decreases if the temperature increases, and conversely increases if the temperature decreases as shown in the figure.
Fail-safe
Function not equipped.
Quarter Window Glass Removal
1. Disconnect the negative battery cable..
2. Remove the following parts:
a. Trunk board.
b. Trunk end trim.
c. Rear scuff plate.
d. Trunk side trim.
e. D-pillar trim.
f. C-pillar trim.
3. Apply protective tape along the edge of the body and the quarter window glass.
WARNING: ...
Fuel Tank Pressure Sensor Inspection
Voltage Inspection
NOTE:
The fuel tank pressure sensor cannot be removed as a single unit. When replacing
the fuel tank pressure sensor, replace it together with the charcoal canister
as a single unit.
1. Disconnect the negative battery cable..
2. Disconnect the fuel tank pres ...
Turbine/Input Shaft Speed Sensor, Output Shaft Speed Sensor [Fw6 A EL, Fw6 Ax
EL]
Purpose/Function
The turbine/input shaft speed sensor detects the rotation speed of the input
shaft (low clutch drum).
The output shaft speed sensor detects the rotation speed of the output shaft
(primary gear).
The turbine/input shaft speed sensor and output shaft speed ...