Purpose
The ambient temperature sensor detects the ambient temperature.
Function
The ambient temperature sensor converts the detected temperature to an electric signal.
Construction
A thermistor-type ambient temperature sensor has been adopted.
The ambient temperature sensor is installed to the shroud panel on the back side of the front bumper.
Operation
The thermistor changes the resistance according to the surrounding temperature.
The resistance decreases if the temperature increases, and conversely increases if the temperature decreases as shown in the figure.

Fail-safe
Function not equipped.
Ambient Temperature Sensor Removal/Installation [Manual Air Conditioner]
Ambient Temperature Sensor [Manual Air Conditioner]Front Stabilizer Removal/Installation
CAUTION:
Performing the following procedures without first removing the front ABS
wheel-speed sensor may possibly cause an open circuit in the wiring harness
if it is pulled by mistake. Before performing the following procedures, disconnect
the front ABS wheel-speed sensor wiring ...
Audio Unit Removal/Installation
Removal
1. Disconnect the negative battery cable.
2. Remove the decoration panel..
3. Remove the bolt.
4. Remove the screws.
NOTE:
When removing the audio unit, the audio unit could interfere with the climate
control unit and scratch the climate control unit. Perform the serv ...
Rear Window Glass Installation
WARNING:
Using a utility knife with bare hands can cause injury. Always wear gloves
when using a utility knife.
CAUTION:
Proper installation of the glass may be difficult if sealant is cracked or
the glass is pushed out by air pressure when a door is opened/closed with al ...