Full-auto Air Conditioner
1. The airflow mode main link is installed to the airflow mode actuator. When removing the airflow mode main link, refer to the airflow mode actuator removal/installation..
Manual Air Conditioner
1. Disconnect the negative battery cable..
2. Remove the glove compartment..
3. Detach the hook (1), then remove the airflow mode rod (2).
4. Remove the screw, then airflow mode main link.
5. Install in the reverse order of removal..
Airflow Mode Main Link Installation Note
CAUTION:
Apply only the specified grease to links. Otherwise abnormal noise or improper operation may result.
1. Align the airflow mode main link hole with the airflow mode sub link projection as shown in the figure.
2. Press the airflow mode main link lightly to the A/C unit, then set the projections of each airflow mode sub link into the grooves of the airflow mode main link.
3. Rotate airflow mode main link and verify that each mode is accessed properly.
Oil Cooler
Purpose, Function
The oil cooler routes engine oil and engine coolant through the interior
and disperses the engine oil heat using the engine coolant. As a result, the
oil temperature is maintained properly to reduce the engine oil deterioration.
Construction
A 9-layered ty ...
Floor Under Cover Removal/Installation
1. Lift up the vehicle.
2. Remove bolts A.
3. Remove fasteners B.
4. Remove the floor under cover No.1.
5. Remove nuts C.
6. Remove fasteners D.
7. Remove bolts E.
8. Remove the floor under cover No.2.
9. Remove bolts F.
10. Remove the fastener G.
11. Remove the floor ...
Rear Window Defroster/Outer Mirror Heater
Outline
Fogging is cleared from the rear window and outer mirror glass by heating
of the filament.
Structural view
System wiring diagram
Vehicles with full-auto air conditioner system
Vehicles with manual air conditioner system
Construction
Rear window defroster
...