Mazda CX-5 Service & Repair Manual: Airflow Mode Control [Full Auto Air Conditioner]
Purpose
-
The airflow mode control changes the airflow mode according to the vehicle environment.
Function
-
The airflow mode control drives the airflow mode actuator according to the mode switch, defroster switch, and the vehicle environment and switches the position of the airflow mode door.
-
The airflow mode control has automatic and manual controls.
-
The airflow mode automatic control performs the following correction:
-
Engine coolant temperature correction (warm-up correction)
Airflow mode automatic control
-
The climate control unit determines the airflow mode based on the current air mix actuator opening angle and solar radiation amount.
-
Determined value used for the airflow mode is changed according to the signal from the solar radiation sensor.
Airflow mode manual control
-
The climate control unit switches the airflow mode based on the MODE switch operation.
|
Airflow mode |
Operation switch |
Air vent |
|
VENT |
Mode switch |
CENTER VENT, SIDE VENT |
|
BI-LEVEL |
CENTER VENT, SIDE VENT, FRONT HEAT, REAR HEAT |
|
|
HEAT |
FRONT HEAT, REAR HEAT, SIDE DEMISTER (low volume), DEFROSTER (low volume), SIDE VENT (low volume) |
|
|
DEF/HEAT |
FRONT HEAT, REAR HEAT, SIDE DEMISTER, DEFROSTER, SIDE VENT (low volume) |
|
|
DEFROSTER |
DEFROSTER switch |
SIDE DEMISTER, DEFROSTER, SIDE VENT (low volume) |
Correction
-
Engine coolant temperature correction (warm-up correction)
-
The engine coolant temperature correction (warm-up correction) prevents cold air from coming out of the lower vents after engine start in winter.
-
The engine coolant temperature correction (warm-up correction) switches the airflow mode according to the increase in the engine coolant temperature.
Construction
-
The airflow volume control consists of the parts indicated in the following table:
|
Input device |
Control part |
Output device |
|
|
|
Operation
1. The climate control unit determines the airflow mode based on the operations of the mode and defroster switches and signals from each sensor which changes according to the vehicle environment.
2. The climate control unit drives the airflow mode actuator according to the results of the airflow mode determination and corrections.
Airflow Mode Actuator [Full Auto Air Conditioner]
Purpose
The airflow mode actuator moves the mode door in the A/C unit to switch the
air vent.
Function
Door open/close function
The airflow mode actuator drives the motor based ...
Airflow Temperature Control [Full Auto Air Conditioner]
Purpose
The airflow temperature control changes the airflow temperature according
to the vehicle conditions.
Function
The air mix actuator is driven and the air mix door positio ...
Other materials:
Main Relay [Skyactiv G 2.0]
Purpose/Function
Supplies power to each part.
Supplies battery voltage to each part based on the signals from the PCM even
though the ignition is switched on or off.
Construction
Installed to the relay and fuse block.
Operation
After the contact poin ...
Center Roof Antenna
Purpose, Function
Converts radio broadcast waves to electric signals and sends the signals
to the audio unit.
Construction
A center roof antenna has been adopted which does not require retraction
or removal before going through an automatic car wash machine.
The ...
Wiper And Washer Switch Removal/Installation
1. Switch the ignition ON (engine off or on).
2. Open the driver's door.
3. Switch the ignition OFF.
4. Disconnect the negative battery cable..
5. Remove the column cover..
6. Rotate the steering wheel in the direction of the arrow shown in the figure
to the angle where the service h ...
