Mazda CX-5 Service & Repair Manual: Air Mix Actuator Inspection [Full Auto Air Conditioner]
CAUTION:
-
If the lever position exceeds the operation range shown in the figure, the circuit in the actuator could be damaged. Always perform an actuator operation inspection with the lever movement within the range shown in the figure.
Driver-side
1. Connect battery positive voltage to air mix actuator terminal C (or B), connect terminal B (or C) to ground, and then verify that the air mix actuator operates as shown in the table.
-
If the operation condition is not normal, replace the air mix actuator.
|
Terminal |
Air mix actuator operation |
|
|
B |
C |
|
|
B+ |
Ground |
COLD > HOT |
|
Ground |
B+ |
HOT > COLD |
2. Verify that the resistance between terminals F and G, E and F matches the air mix actuator operation as shown in the graph.
-
If the operation condition and resistance are not normal, replace the air mix actuator.
Passenger-side
1. Connect battery positive voltage to air mix actuator terminal C (or B), connect terminal B (or C) to ground, and then verify that the air mix actuator operates as shown in the table.
-
If the operation condition is not normal, replace the air mix actuator.
|
Terminal |
Air mix actuator operation |
|
|
B |
C |
|
|
B+ |
Ground |
HOT > COLD |
|
Ground |
B+ |
COLD > HOT |
2. Verify that the resistance between terminals F and G, E and F matches the air mix actuator operation as shown in the graph.
-
If the operation condition and resistance are not normal, replace the air mix actuator.
Air Intake Control [Full Auto Air Conditioner]
Purpose
The air intake control switches the air intake port (FRESH/REC) according
to the vehicle environment.
Function
The air intake control drives the air intake actuator and ...
Air Mix Actuator Removal/Installation [Full Auto Air Conditioner]
Driver-side
1. Disconnect the negative battery cable..
2. Remove the following parts:
a. Side wall (driver-side).
b. Front heat duct (LH).
3. Disconnect the air mix actuator connector.
...
Other materials:
Car Navigation System Does Not Operation [Car Navigation System]
Possible DTC
Even if the map screen is touched, the car-navigation system cannot be
operated
POSSIBLE CAUSE
Audio unit malfunction (bad LCD panel)
Car-navigation unit malfunction
Diagnosti ...
Propeller Shaft Inspection
1. Measure the propeller shaft center runout using the dial gauge.
If it exceeds the maximum specification, replace the propeller shaft as a
single component.
Propeller shaft maximum runout
0.8 mm {0.031 in}
2. Inspect the play and rotation of the joint by turning ...
Shift Solenoid No.2 [Fw6 A EL, Fw6 Ax EL]
Purpose/Function
Shift solenoid No.2 adjusts the hydraulic pressure in the 2-6 brake circuit
based on the current demand from the TCM according to the vehicle conditions.
Construction
Shift solenoid No.2 is installed to the solenoid control valve body.
Shift solenoid N ...
