Chevrolet Spark manuals

Mazda CX-5 Service & Repair Manual: Air Intake Control [Full Auto Air Conditioner]

Mazda CX-5 Service & Repair Manual / HVAC / A/C / Air Intake Control [Full Auto Air Conditioner]

Purpose

Function

Air intake automatic control

1. Calculates the cabin temperature value based on the ambient temperature and sunlight intensity.

2. Compares the calculated cabin temperature value and current cabin temperature.

3. Determines the air intake mode.


Air intake manual control


Air intake mode

REC switch operation

FRESH

Fixed to FRESH when the FRESH switch is turned on during REC mode

REC

Fixed to REC when the RECIRCULATE switch is turned on during FRESH mode


REC mode control under severe heat

Correction

Construction


Input device

Control part

Output device

  • Recirculate switch (climate control unit)

  • Fresh switch (climate control unit)

  • Defroster switch (climate control unit)

  • Ambient temperature sensor

  • Passenger compartment temperature sensor

  • Solar radiation sensor

  • Refrigerant pressure sensor

  • Climate control unit

  • PCM

  • Instrument cluster

  • Air intake actuator

  • Air intake door


Operation

1. The climate control determines the air intake mode based on the operations of the REC, FRESH, defroster switches and signals from each sensor which changes according to the vehicle environment.

2. The climate control unit drives the air intake actuator according to the result of the air intake mode determination and corrections.


Air Intake Actuator [Manual Air Conditioner]
Purpose The air intake actuator moves the air intake door in the blower unit to switch the air intake port. Function The air intake actuator drives the motor based on the signal ...

Air Mix Actuator Inspection [Full Auto Air Conditioner]
CAUTION: If the lever position exceeds the operation range shown in the figure, the circuit in the actuator could be damaged. Always perform an actuator operation inspection with the lev ...

Other materials:

C Pillar Trim Removal/Installation
1. Disconnect the negative battery cable.. 2. Remove the following parts: a. Trunk board. b. Trunk end trim. c. Rear scuff plate. d. Trunk side trim. e. D-pillar trim. 3. Partially peel back the seaming welt. 4. Remove the fastener A. 5. Take the shaded area shown in the figure ...

Sas Control Module Configuration (Using As Built Data) [Standard Deployment Control System]
NOTE: If the configuration is performed using As-Built data, the set value of the personalization function is reset to the initial value (condition when shipped from factory). Verify the set value with the customer and perform the personalization function setting after performing th ...

Oil Pump
Outline The oil pump has a mechanism for feedback control of oil pressure. As a result, an oil pressure increase of more than the set pressure is suppressed and oil pump drive resistance is reduced. In addition, because the set pressure can be changed (oil pressure two-step control) ...

© 2016-2022 Copyright www.mcx5.org