Chevrolet Spark manuals

Mazda CX-5 Service & Repair Manual: Air Intake Actuator Inspection [Full Auto Air Conditioner]

Mazda CX-5 Service & Repair Manual / Engine / Intake / Air Intake Actuator Inspection [Full Auto Air Conditioner]

1. Connect battery positive voltage to air intake actuator terminal B (or C), connect terminal C (or B) to ground, and then verify that the air intake actuator operates as shown in the table.



Terminal

Air intake actuator operation

B

C

B+

Ground

FRESH > RECIRCULATE

Ground

B+

RECIRCULATE > FRESH


Air Filter Removal/Installation
1. Remove the glove compartment.. 2. Remove the air filter. 3. Install in the reverse order of removal. ...

Air Intake Actuator Inspection [Manual Air Conditioner]
1. Connect battery positive voltage to air intake actuator terminal B (or C), connect terminal C (or B) to ground, and then verify that the air intake actuator operates as shown in the table. ...

Other materials:

Shroud Panel Removal/Installation
CAUTION: Since the servicing is performed with the hood open, secure the hood using a piece of wood to prevent it from falling. 1. Disconnect the negative battery cable.. 2. Remove the following parts: a. Seal board upper. b. Front bumper. c. Front combination light. d. Sh ...

Filament Repair
1. Clean the filament using isopropyl alcohol. 2. Attach tape to both sides of the filament. 3. Using a small brush or marking pen, apply silver paint. 4. After 2—3 min, carefully remove the tape without damaging the applied area. CAUTION: Do not operate the rear window defro ...

Oil Control Valve (OCV) Inspection [Skyactiv G 2.0]
Coil Resistance Inspection 1. Disconnect the negative battery cable.. 2. Remove the plug hole plate.. 3. Disconnect the OCV connector. 4. Measure the resistance between terminals A and B using an ohmmeter. OCV coil resistance 6.9—7.5 ohms [20°C {68°F}] If ...

© 2016-2022 Copyright www.mcx5.org