Mazda CX-5 Service & Repair Manual: Air Fuel Ratio (A/F) Sensor

Mazda CX-5 Service & Repair Manual / Engine / Control / Air Fuel Ratio (A/F) Sensor

Purpose/Function

Detects the oxygen concentration (all-range air/fuel ratio) in the exhaust gas as basic information for mainly determining the fuel injection amount.
Detects the oxygen concentration (all-range air/fuel ratio) in the exhaust gas and inputs it to the PCM as an oxygen concentration (all-range air/fuel ratio) signal.

Construction

Installed to the exhaust manifold.
A zirconium element has been adopted as the detecting element for detecting the oxygen concentration (all-range air/fuel ratio).

Operation

Inputs the signal, which fluctuates according to the oxygen concentration (all-range air/fuel ratio), to the PCM.

A/F sensor characteristic

Fail-safe


DTC No.	Fail-safe function
P0031:00	Stops the fuel feedback control.
P0032:00	Stops the fuel feedback control.
P0130:00	Fixes the duty value of the A/F sensor heater. Stops the fuel feedback control.
P0131:00	Fixes the duty value of the A/F sensor heater. Stops the fuel feedback control.
P0132:00	Fixes the duty value of the A/F sensor heater. Stops the fuel feedback control.
P0134:00	Fixes the duty value of the A/F sensor heater. Stops the fuel feedback control.
P064D:00	Fixes the duty value of the A/F sensor heater. Stops the fuel feedback control.
P2237:00	Fixes the duty value of the A/F sensor heater. Stops the fuel feedback control.
P2243:00	Fixes the duty value of the A/F sensor heater. Stops the fuel feedback control.
P2251:00	Fixes the duty value of the A/F sensor heater. Stops the fuel feedback control.

Air Fuel Ratio (A/F) Sensor Removal/Installation

WARNING: A hot engine and exhaust system can cause severe burns. Turn off the engine and wait until they are cool before removing the exhaust system. CAUTION: Do not allow fla ...

Camshaft Position (CMP) Sensor Inspection

Intake CMP Sensor Visual inspection CAUTION: When replacing the CMP sensor, make sure there is no foreign material on it such as metal shavings. If it is installed with foreign material, ...

Other materials:

Control System Personalization Features Setting Procedure
1. Connect the M-MDS to DLC-2. 2. After the vehicle is identified, select the following items from the initial screen of the M-MDS. Select the “Module Programming”. Select “Programmable Parameters”. Select menu in the R_BCM. 3. Select an item name, and then ...

Tcs/DSC Indicator Light
Purpose/Function The TCS/DSC indicator light, built into the instrument cluster, informs the driver of the following vehicle conditions. TCS is operating. (Drive wheel is slipping.) DSC is operating. (Vehicle side-slip condition.) Roll over mitigation (RO ...

Center Accessory Socket Removal/Installation
1. Disconnect the negative battery cable.. 2. Remove the upper console.. 3. Insert a tape-wrapped flathead screwdriver into the gap between the cap tab and socket. 4. Move the flathead screwdriver in the direction of the arrow (1) shown in the figure, press the center accessory socket ...