Purpose
The air bag system warning light notifies the driver of a malfunction in the SRS air bag system.
Function
If a malfunction occurs in the SRS air bag system, the air bag system warning light illuminates or flashes.

Construction
LEDs (light-emitting diode) have been adopted for the air bag system warning light.
The air bag system warning light is built into the instrument cluster.
Operation
When the ignition is switched ON, the instrument cluster illuminates the air bag system warning light for a specified period to indicate that the SRS air bag system is performing initialization diagnostics. If there is no malfunction in the SRS air bag system, the indicator light turns off.
If the SAS control module detects a malfunction in the SRS air bag system, it sends a warning signal to the instrument cluster via CAN communication. The instrument cluster illuminates or flashes the air bag system warning light based on the warning signal it receives to display the DTC.
If there is a malfunction in the SRS air bag system, the air bag system warning light displays DTCs according to the following patterns:

If there are several malfunctions in the SRS air bag system, the DTC of the highest priority ranking is displayed first.
Fail-safe
Function not equipped.
Air Bag System Warning Light [Standard Deployment Control System]
Automatic Transaxle Warning Light [Fw6 A EL, Fw6 Ax EL]Rear Center Seat Belt Removal/Installation
CAUTION:
The ELR (emergency locking retractor) has a spring that will unwind if the
retractor cover is removed. The spring cannot be rewound by hand. If this occurs,
the ELR will not work properly. Therefore, do not disassemble the retractor.
1. Press the release switch, then dis ...
Rear Bumper Removal/Installation
CAUTION:
Affix the protective tape to the position (body side) shown in the figure.
1. Disconnect the negative battery cable..
2. Remove the rear combination light..
3. Remove fasteners A.
4. Pull the rear over fender in the direction of the arrow shown in the figure
...
Starter Interlock Switch Removal/Installation [C66 M R]
1. Disconnect the negative battery cable..
2. Disconnect the starter interlock switch connector.
3. Remove the starter interlock using the following procedure:
a. Detach hook A in the direction of the arrow shown in the figure.
b. Slide the starter interlock switch in the direction of th ...