Mazda CX-5 Service & Repair Manual: Air Bag System Warning Alarm [Standard Deployment Control System]

Mazda CX-5 Service & Repair Manual / Engine / Control / Air Bag System Warning Alarm [Standard Deployment Control System]

Purpose

The air bag system warning alarm notifies the driver that a malfunction occurred in the air bag system instead of the air bag system warning light.

Function

If a malfunction occurs in the air bag system while the air bag system warning light cannot illuminate, the air bag system warning alarm sounds.

Construction

The air bag system warning alarm sounds a buzzer in the instrument cluster.

Operation

The SAS control module sends the air bag system warning alarm trigger signal to the instrument cluster via CAN communication to sound the buzzer in the instrument cluster.
If all of the following conditions are met, the SAS control module sends the air bag system warning alarm trigger signal to the instrument cluster.

SAS control module detects DTC B00D2:29 (air bag system warning light (during communication related malfunction))
SAS control module detects DTCs other than DTC B00D2:29 (Except for air bag system warning light does not illuminate DTC)

Refer to the air bag system warning alarm for the air bag system warning alarm sound interval.

Fail-safe

Function not equipped.

Air Bag System Service Warnings [Two Step Deployment Control System]

Air Bag Module Inspection Inspecting an air bag module using a tester can operate (deploy) the air bag module, which may cause serious injury. Do not use a tester to inspect an air bag mo ...

Air Bag System Warning Alarm [Two Step Deployment Control System]

Purpose The air bag system warning alarm notifies the driver that a malfunction occurred in the air bag system instead of the air bag system warning light. Function If a malfunc ...

Other materials:

Break-In Period
No special break-in is necessary, but a few precautions in the first 1,000 km (600 miles) may add to the performance, economy, and life of your Mazda. • Do not race the engine. • Do not maintain one constant speed, either slow or fast, for a long period of time. • Do not drive constantl ...

A Pillar Trim Removal/Installation
1. Partially peel back the seaming welt. 2. Take the shaded area shown in the figure, and pull the A-pillar trim in the direction of the arrow (1) while detaching clip A, clips B. 3. Cut the lead wire connecting clips B and grommet using a nipper. 4. Pull the A-pillar trim in the dir ...

Rear ABS Wheel Speed Sensor Inspection [Awd]
Installation Visual Inspection 1. Inspect the following items: If there is any malfunction, replace the applicable part. a. Excessive play of the ABS wheel-speed sensor b. Deformation of the ABS wheel-speed sensor c. Deformation or damage of the ABS sensor rotor Clearance Inspec ...