Chevrolet Spark manuals

Mazda CX-5 Service & Repair Manual: Air Bag System [Two Step Deployment Control System]

Mazda CX-5 Service & Repair Manual / Engine / Control / Air Bag System [Two Step Deployment Control System]

Outline


Item

Outline

SAS control module

  1. A yaw rate sensor and a low-G sensor has been added.

  2. Recognizes actually equipped air bag module or pre-tensioner seat belt based on module configuration.

Crash zone sensor

  • Detects degree of impact, converts to an electrical signal, and sends the signal to the SAS control module.

Side air bag sensor

Pressure sensor

Driver-side air bag module

  • Adopted to improve safety in frontal collisions.

Passenger-side air bag module

Side air bag module

  • Chest-protection type side air bag module is used in accordance with the adoption of the curtain air bag module.

Curtain air bag module

  • Adopted to improve safety in lateral collisions.

Pre-tensioner seat belt

  • Gear-type pre-tensioner seat belt has been adopted.

Lap pre-tensioner seat belt

  • Wire-type lap pre-tensioner seat belt has been adopted.

Air bag system warning light

  • LED has been adopted.


Structural View


Wiring Diagram


Air Bag System [Standard Deployment Control System]
Outline The air bag system is a device that supplements the passenger restraint function of the seat belts. The air bag system will not have the designed effect if the seat belts are not ...

Barometric Pressure (Baro) Sensor Inspection
Voltage Inspection NOTE: Because the BARO sensor is integrated in the PCM, replacing the BARO sensor includes replacement of the PCM. 1. Connect the M-MDS to the DLC?2. 2. Switch t ...

Other materials:

Money-Saving Suggestions
How you operate your Mazda determines how far it will travel on a tank of fuel. Use these suggestions to help save money on fuel and repairs. • Avoid long warm-ups. Once the engine runs smoothly, begin driving. • Avoid fast starts. • Keep the engine tuned. Follow the maintenance sched ...

PID/Data Monitor Inspection [Two Step Deployment Control System]
1. Connect the M-MDS to the DLC-2. 2. After the vehicle is identified, select the following items from the initialization screen of the M-MDS. a. Select “DataLogger”. b. Select “Modules”. c. Select “RCM”. 3. Select the applicable PID from the PID table. 4. Verify the PID da ...

Air Cleaner Element Inspection
1. Remove the air cleaner element.. 2. Inspect the following items: Has the replacement interval past? Is the air cleaner element soiled, damaged, or bent? Are the air cleaner case and the air cleaner element correctly sealed? Is the correct air cleaner element inst ...

© 2016-2022 Copyright www.mcx5.org