Chevrolet Spark manuals

Mazda CX-5 Service & Repair Manual: Air Bag System [Standard Deployment Control System]

Mazda CX-5 Service & Repair Manual / Engine / Control / Air Bag System [Standard Deployment Control System]

Outline


Item

Outline

SAS control module

  1. A yaw rate sensor and a low-G sensor has been added.

  2. Recognizes actually equipped air bag module or pre-tensioner seat belt based on module configuration.

Crash zone sensor

  • Detects degree of impact, converts to an electrical signal, and sends the signal to the SAS control module.

Side air bag sensor

Driver-side air bag module

  • Adopted to improve safety in frontal collisions.

Passenger-side air bag module

Side air bag module

  • Chest-protection type side air bag module is used in accordance with the adoption of the curtain air bag module.

Curtain air bag module

  • Adopted to improve safety in lateral collisions.

Pre-tensioner seat belt

  • Gear-type pre-tensioner seat belt has been adopted.

Air bag system warning light

  • LED has been adopted.


Structural View


Wiring Diagram


Air Bag System Warning Light [Two Step Deployment Control System]
Purpose The air bag system warning light notifies the driver of a malfunction in the SRS air bag system. Function If a malfunction occurs in the SRS air bag system, the air bag ...

Air Bag System [Two Step Deployment Control System]
Outline The air bag system is a device that supplements the passenger restraint function of the seat belts. The air bag system will not have the designed effect if the seat belts are not ...

Other materials:

Lap Pre Tensioner Seat Belt [Two Step Deployment Control System]
Purpose The lap pre-tensioner seat belts retract and tighten the seat belt webbing to protect the front passengers during a collision. Function The lap pre-tensioner seat belts operate (deploy) based on the operation signal from the SAS control module to instantly retract a ...

Rear Washer Hose Removal/Installation
1. Disconnect the negative battery cable.. 2. Remove the front over fender.. 3. Remove the mudguard (RH).. 4. Disconnect the rear washer hose A from the washer motor. 5. Remove the rear washer hose A from the washer tank hook. 6. Remove the rear washer hose A from clips A and B. 7. Disco ...

Control Valve Body Removal/Installation [Fw6 A EL, Fw6 Ax EL]
On-Vehicle Removal WARNING: A hot transaxle and ATF can cause severe burns. Turn off the engine and wait until they are cool. Using compressed air can cause dirt and other particles to fly out, causing injury to the eyes. Wear protective eyeglasses whenever using compressed ai ...

© 2016-2026 Copyright www.mcx5.org