WARNING:
A live (undeployed) air bag module, pre-tensioner seat belt or lap pre-tensioner seat belt may accidentally operate (deploy) when it is disposed of and cause serious injury. Always refer to the “AIR BAG MODULE AND PRE-TENSIONER SEAT BELT DEPLOYMENT PROCEDURES” and dispose of air bag modules, pre-tensioner seat belts and lap pre-tensioner seat belts in a deployed condition.
The air bag modules, pre-tensioner seat belts and lap pre-tensioner seat belts are very hot immediately after they are deployed. You can be burned. Do not touch an air bag module, pre-tensioner seat belt and lap pre-tensioner seat belt for at least 15 min after deployment.
Pouring water on the deployed air bag module, pre-tensioner seat belt and lap pre-tensioner seat belt is dangerous. The water will mix with the residual gases to form a gas that can make breathing difficult. Do not pour water on the deployed air bag module, pre-tensioner seat belt and lap pre-tensioner seat belt.
The deployed air bag module, pre-tensioner seat belt or lap pre-tensioner seat belt may contain deposits of sodium hydroxide, a caustic byproduct of the gas-generated combustion. If this substance gets into your eyes or on your hands, it can cause irritation and itching. When handling the deployed air bag module, pre-tensioner seat belt and lap pre-tensioner seat belt, wear gloves and safety glasses.
1. Remove the deployed air bag module, pre-tensioner seat belt or lap pre-tensioner seat belt.
2. Put the air bag module, pre-tensioner seat belt or lap pre-tensioner seat belt in a plastic bag, seal the bag, and then dispose of it.
Front Seat Back Trim Removal/Installation
WARNING:
Handling a side air bag improperly can accidentally operate (deploy) the
air bag, which may seriously injure you. Read the service warnings/cautions
in the Workshop Manual before handling the front seat (side air bag integrated)..
If the sliding mechanisms on both ...
Glass Antenna Inspection
1. Disconnect the negative battery cable..
2. Partially peel back the seaming welt.
3. Remove the liftgate upper trim..
4. Disconnect antenna feeder No.3 connector..
5. Visually inspect the glass antenna for damage.
6. Verify that the continuity between the glass antenna terminals is as in ...
Discharge Headlight Service Warnings
Discharge Headlight Service Warnings
When replacing a discharge headlight bulb, performing the servicing with
the negative battery cable connected or in a wet work area could result in electrocution.
When replacing a discharge headlight bulb, perform the servicing under the following
...