WARNING:
A live (undeployed) air bag module, pre-tensioner seat belt or lap pre-tensioner seat belt may accidentally operate (deploy) when it is disposed of and cause serious injury. Always refer to the “AIR BAG MODULE AND PRE-TENSIONER SEAT BELT DEPLOYMENT PROCEDURES” and dispose of air bag modules, pre-tensioner seat belts and lap pre-tensioner seat belts in a deployed condition.
The air bag modules, pre-tensioner seat belts and lap pre-tensioner seat belts are very hot immediately after they are deployed. You can be burned. Do not touch an air bag module, pre-tensioner seat belt and lap pre-tensioner seat belt for at least 15 min after deployment.
Pouring water on the deployed air bag module, pre-tensioner seat belt and lap pre-tensioner seat belt is dangerous. The water will mix with the residual gases to form a gas that can make breathing difficult. Do not pour water on the deployed air bag module, pre-tensioner seat belt and lap pre-tensioner seat belt.
The deployed air bag module, pre-tensioner seat belt or lap pre-tensioner seat belt may contain deposits of sodium hydroxide, a caustic byproduct of the gas-generated combustion. If this substance gets into your eyes or on your hands, it can cause irritation and itching. When handling the deployed air bag module, pre-tensioner seat belt and lap pre-tensioner seat belt, wear gloves and safety glasses.
1. Remove the deployed air bag module, pre-tensioner seat belt or lap pre-tensioner seat belt.
2. Put the air bag module, pre-tensioner seat belt or lap pre-tensioner seat belt in a plastic bag, seal the bag, and then dispose of it.
Fog Lights
Use this switch to turn on the fog lights.
The fog lights will improve visibility at night and during foggy conditions.
To turn the fog lights on, rotate the fog light switch to the
position.
The headlight switch must be in the
position before turning on the fog lights.
To turn the fog lig ...
Ignition Coil/Ion Sensor Removal/Installation [Skyactiv G 2.0]
1. Disconnect the negative battery cable..
2. Remove the plug hole plate..
3. Remove in the order indicated in the table.
4. Install in the reverse order of removal.
1
Connector
2
Ignition coil
...
Interior Lights
Overhead Lights
Front Map Lights
When the overhead light switch is in the door or off position, press the lens
to illuminate the front map lights, and then press the lens again to turn them off.
NOTE
The front map lights will not turn off even if the lens is pressed in the
following ca ...