Only use genuine Mazda accessories or the equivalent requiring no greater than 120 W (DC 12 V, 10 A).
Front
The ignition must be switched to ACC or ON.
Center, Rear
The accessory sockets can be used regardless of whether the ignition is on or off.
CAUTION
●To prevent accessory socket damage or electrical failure, pay attention to the following:
● Do not use accessories that require more than 120 W (DC 12 V, 10 A).
● Do not use accessories that are not genuine Mazda accessories or the equivalent.
● Close the cover when the accessory socket is not in use to prevent foreign objects and liquids from getting into the accessory socket.
● Correctly insert the plug into the accessory socket.
● Do not insert the cigarette lighter into the accessory socket.
● Noise may occur on the audio playback depending on the device connected to the accessory socket.
● Depending on the device connected to the accessory socket, the vehicle's electrical system may be affected, which could cause the warning light to illuminate.
Disconnect the connected device and make sure that the problem is resolved. If the problem is resolved, disconnect the device from the socket and switch the ignition off. If the problem is not resolved, consult an Authorized Mazda Dealer.
NOTE
To prevent discharging of the battery, do not use the socket for long periods with the engine off or idling.
Connecting the accessory socket
1. Open the lid." 2. Pass the connection plug cord through the cutout of the console and insert the plug into the accessory socket.
Air Bag System Service Warnings [Two Step Deployment Control System]
Air Bag Module Inspection
Inspecting an air bag module using a tester can operate (deploy) the air
bag module, which may cause serious injury. Do not use a tester to inspect an
air bag module. Always use the on-board diagnostic function to diagnose the
air bag module for malfunctions ...
Front Frame (Rear) Removal [Panel Replacement]
Symbol Mark
Removal Procedure
1. Drill the 33 locations shown in the figure.
NOTE:
When drilling, do not drill a hole all the way through or there could be
a problem when installing the new part.
2. Remove the front frame (rear). ...
Rear Brake (Disc) Inspection
Brake Judder Repair Hints
Description
1. Brake judder concern has the following 3 characteristics:
Steering wheel vibration
1. The steering wheel vibrates in the rotation direction. This characteristic
is most noticeable when applying brakes at a vehicle speed of 100—140 km/h {62.2—86.9
...