Mazda CX-5 Service & Repair Manual: Accelerator Pedal Position (App) Sensor

Mazda CX-5 Service & Repair Manual / Engine / Control / Accelerator Pedal Position (App) Sensor

Purpose/Function

Detects the accelerator pedal depression amount as basic information for mainly determining the throttle valve opening.
Detects the accelerator pedal depression amount and inputs it to the PCM as an accelerator pedal opening angle signal.

Construction

Built into the accelerator pedal.
A hall element has been adopted as the detecting element for detecting the accelerator pedal depression amount.

Operation

Inputs the signal, which fluctuates according to the throttle valve opening/closing, to the PCM.

APP sensor characteristic

Fail-safe


DTC No.	Fail-safe function
P2122:00	Regulates the upper limit of the APP sensor output.
P2123:00	Regulates the upper limit of the APP sensor output.
P2127:00	Regulates the upper limit of the APP sensor output.
P2128:00	Regulates the upper limit of the APP sensor output.
P2138:00	Restricts the upper limit of the engine speed. Stops the drive-by-wire control (throttle valve is open at approx. 8° by return spring force).

Accelerator Pedal Position (App) Sensor Inspection

Voltage Inspection NOTE: Because the APP sensor is integrated in the accelerator pedal, replacing the APP sensor includes replacement of the accelerator pedal. 1. Connect the M-MDS t ...

Air Fuel Ratio (A/F) Sensor Heater Control

Outline Based on the control of the A/F sensor heater, a stabilized oxygen concentration is detected even at low exhaust temperatures, and feedback control of fuel injection even at cold ...

Other materials:

Washer Nozzle
Purpose The washer nozzle sprays the washer fluid sent from the washer motor to the optimum positions on the windshield. Construction A ball-shaped spray orifice is set inside the washer nozzle which can be adjusted up or down. The washer nozzle is moved u ...

Seat Track Position Sensor Removal/Installation [Two Step Deployment Control System]
1. Switch the ignition to off. 2. Disconnect the negative battery cable and wait for 1min or more.. 3. Remove the front driver’s seat.. 4. Disconnect the connector from the seat track position sensor by pressing the connector tab and pulling out the lock lever in the direction of the arro ...

Plastic Parts Heat Resisting Temperature [Plastic Body Parts]
Part Name Code Material Name Heat resisting Temperature°C{°F} Windshield molding PVC POLYVINYLCHLORIDE 95 {203} Cowl grille PP POLYPROPYLENE ...