Mazda CX-5 Service & Repair Manual: ABS
- ABS Control
- ABS Wheel Speed Sensor And ABS Sensor Rotor
- Brake System/ABS Warning Light
- Front ABS Wheel Speed Sensor Inspection
- Front ABS Wheel Speed Sensor Removal/Installation
- Rear ABS Wheel Speed Sensor Inspection [2 Wd]
- Rear ABS Wheel Speed Sensor Inspection [Awd]
- Rear ABS Wheel Speed Sensor Removal/Installation
Tcs/DSC Indicator Light
Purpose/Function
The TCS/DSC indicator light, built into the instrument cluster, informs the
driver of the following vehicle conditions.
TCS is operating. (Drive wheel is slippi ...
ABS Control
Outline
ABS control occurs when wheel slip is determined by the DSC CM (based on
the four ABS wheel-speed sensors). Then, the DSC HU inlet and outlet solenoid
valves are operated and brak ...
Other materials:
Power Window Motor Inspection
Front driver side
1. Disconnect the negative battery cable..
2. Remove the inner garnish..
3. Remove the front door trim..
4. Disconnect the power window motor connector.
5. Apply battery positive voltage and connect the ground to power window motor
terminals E and F, and then inspect the ...
Magnet Clutch [Full Auto Air Conditioner]
Purpose
The magnetic clutch transmits the rotation force from the engine to the shaft
in the A/C compressor.
Function
The magnetic clutch engages or disengages the magnetic clutch and the A/C
turns on or off by switching the power transmission from the engine.
C ...
PCM Removal/Installation
CAUTION:
There are two types of PCM settings. If the incorrect PCM is installed, it
could cause interference with engine control.
When replacing the PCM, verify the first four digits of the part number indicated
on the PCM label before replacement, and replace the PCM with one ...
