Mazda CX-5 Service & Repair Manual: 4WD
- All Wheel Drive System
- Awd Control Module
- Awd Control Module Configuration
- Awd Control Module Inspection
- Awd Control Module Removal/Installation
- Awd Solenoid Inspection
- Awd Warning Light
- Coupling Component Calibration Data Writing
- Coupling Component Removal/Installation
- Electronic Control Coupling
- Fuel Gauge Sender Unit Inspection [Awd]
- Fuel Gauge Sender Unit Removal/Installation [Awd]
- Planetary Gear [Fw6 A EL, Fw6 Ax EL]
- Rear ABS Wheel Speed Sensor Inspection [Awd]
- Rear Crossmember Removal/Installation [Awd]
- Rear Stabilizer Removal/Installation [Awd]
- Rear Upper Arm Removal/Installation [Awd]
- Transfer
- Transfer Oil Inspection [Fw6 Ax EL]
- Transfer Oil Replacement [Fw6 Ax EL]
- Transfer Oil Seal Replacement [Fw6 Ax EL]
- Transfer Removal/Installation [Fw6 Ax EL]
- Turbine/Input Shaft Speed Sensor, Output Shaft Speed Sensor [Fw6 A EL, Fw6 Ax EL]
- Wheel Hub Component Removal/Installation [Awd]
General Procedures (Front And Rear Axles)
Wheel and Tire Installation
1. When installing the wheels and tires, tighten the wheel nuts in a criss-cross
pattern to the following tightening torque.
Tightening torque
108—147 N ...
All Wheel Drive System
Outline
The electronic all-wheel drive (AWD) control system automatically and optimally
controls drive torque distribution for the front and rear wheels. Due to this
off-road mobility and ...
Other materials:
Seat Track Position Sensor Removal/Installation [Two Step Deployment Control
System]
1. Switch the ignition to off.
2. Disconnect the negative battery cable and wait for 1min or more..
3. Remove the front driver’s seat..
4. Disconnect the connector from the seat track position sensor by pressing the
connector tab and pulling out the lock lever in the direction of the arro ...
Push Button Start Inspection
1. Remove the push button start..
2. Verify that the continuity between the push button start terminals is as indicated
in the table.
If the continuity can be verified as indicated in the table, go to the next
step.
If not as indicated in the table, replace the push bu ...
Seat Warmer Control Unit Removal/Installation
WARNING:
Handling a side air bag improperly can accidentally operate (deploy) the
air bag, which may seriously injure you. Read the service warnings/cautions
in the Workshop Manual before handling the front seat (side air bag integrated)..
1. Switch the ignition off (LOCK).
2. ...
