Chevrolet Spark manuals

Audi A4 (B9) 2016-2022 Owner's Manual: Windshield washer system

Checking and Filling
Fig. 163 Motor compartment: washer fluid reservoir cap

The windshield washer reservoir contains the cleaning solution for the windshield/rear window* and the headlight washer system. The reservoir capacity can be found.

To reduce the risk of lime scale deposits on the spray nozzles, use clean water with low amounts of calcium. Always add window cleaner to the water.

When the outside temperatures are cold, an anti-freezing agent should be added to the water so that it does not freeze.

Messages

The following messages may appear depending on the vehicle equipment:

Please add washer fluid

Fill the washer fluid for the windshield washer system and the headlight washer system* when the ignition is switched off.

Note

Service interval display

The service interval display detects when your vehicle is due for service.

The service interval display works in two stages:

Checking service intervals

You can check the remaining distance or time until the next oil change or next inspection in the Infotainment system.

Applies to MMI: Select on the home screen: VEHICLE > Settings & Service > Service intervals.

Resetting the indicator

An authorized Audi dealer or authorized Audi Service Facility will reset the service interval display after performing service.

If you have changed the oil yourself, you must reset the oil change interval.

Applies to: MMI: To reset the display, select on the home screen: VEHICLE > Settings & Service > Service intervals.

WARNING

Inadequate service, a lack of service, or failing to adhere to the service intervals can result in the vehicle breaking down in traffic, accidents, and serious injuries.

Note

Charging the 12 volt vehicle battery
Fig. 162 Engine compartment: connectors for a charger or jump start cables Observe the safety precautions > General information, in Battery general information. Requirement: only use chargers with ...

Wheels
...

Other materials:

Tire Labeling
Federal law requires tire manufacturers to place standardized information on the sidewall of all tires. This information identifies and describes the fundamental characteristics of the tire and also provides a tire identification number for safety standard certification and in case of a recall ...

Fuel Pump Control
Outline By switching the fuel pump discharge amount, reduced power consumption and improved fuel economy have been realized. The PCM determines the optimum fuel pump drive force according to the engine operation conditions, and sends the fuel pump drive signal to the fuel pump ...

PID/Data Monitor Inspection [Two Step Deployment Control System]
1. Connect the M-MDS to the DLC-2. 2. After the vehicle is identified, select the following items from the initialization screen of the M-MDS. a. Select “DataLogger”. b. Select “Modules”. c. Select “RCM”. 3. Select the applicable PID from the PID table. 4. Verify the PID da ...

© 2016-2022 Copyright www.mcx5.org