Chevrolet Spark manuals

Audi A4 (B9) 2016-2022 Owner's Manual: Suspension

Adaptive dampers

Applies to: vehicles with suspension control

The adaptive dampers are an electronically-controlled damping system. The firmness of the suspension will adapt to the driving conditions and the driving situation. The settings depend on the selected Audi drive select* mode.

Ground clearance

The vehicle height and clearance can be influenced by the following factors:

WARNING

To reduce the risk of injury, make sure no one gets pinched when the vehicle level is changing, for example when cleaning the underbody or the wheel housings.

Note

Always make sure there is enough clearance above and below the vehicle. This is especially important for entrances with height restrictions, for example, before driving into underground garages. You could also scrape the ground when driving over the edges of curbs or on steep ramps, which could damage your vehicle.

Messages

The following messages may appear depending on the vehicle equipment:

Suspension: malfunction! You can continue driving

There is a malfunction. See an authorized Audi dealer or authorized Audi Service Facility for assistance.

Audi drive select
Introduction Applies to: vehicles with Audi drive select Drive select makes it possible to experience different types of vehicle characteristics in one vehicle. With different driving modes, the driv ...

Steering
Description Electromechanical steering supports the driver's steering movements by electronically adapting the power steering depending on the vehicle speed. The settings depend on the selected Audi ...

Other materials:

Fuel Tank Removal/Installation
WARNING: Fuel is very flammable liquid. If fuel spills or leaks from the pressurized fuel system, it will cause serious injury or death and facility breakage. Fuel can also irritate skin and eyes. To prevent this, always complete the “Fuel Line Safety Procedure”, while referring ...

Differential Oil Temperature Sensor
Purpose, Function The differential oil temperature sensor detects the rear differential oil temperature based on the resistance of the thermistor, and inputs it to the AWD CM. Construction The differential oil temperature sensor is installed in the rear differential carr ...

A Pillar Trim Removal/Installation
1. Partially peel back the seaming welt. 2. Take the shaded area shown in the figure, and pull the A-pillar trim in the direction of the arrow (1) while detaching clip A, clips B. 3. Cut the lead wire connecting clips B and grommet using a nipper. 4. Pull the A-pillar trim in the dir ...

© 2016-2022 Copyright www.mcx5.org