Chevrolet Spark manuals

Audi A4 (B9) 2016-2022 Owner's Manual: Operating Audi adaptive cruise control

Audi A4 (B9) 2016-2022 Owner's Manual / Assist systems / Driver assistance / Operating Audi adaptive cruise control

Applies to: vehicles with Audi adaptive cruise control

Driver assistance
Fig. 110 Operating lever: operating adaptive cruise control

Driver assistance
Fig. 111 Operating lever: changing the speed

Switching on

Storing the speed and activating regulation

If you have switched the system on, you can set the current speed as the "regulated speed" and activate regulation:

You can set any speed between 15 mph (20 km/h)1) and the maximum possible speed range 32), fig. 108.

1) Analog instrument cluster: 20 mph (30 km/h)
2) Depends on the country and engine

Pausing cruise control

The control can be stopped at any time:

The indicator light turns off.

Resuming regulation

The previously set speed can be resumed at any time after a pause.

Changing the speed

Applies to: vehicles with predictive control: Predictive control can automatically adjust the set speed based on traffic and road conditions.

Preselecting a speed

You can also preselect the speed when adaptive cruise control is not active by moving the lever in the desired direction (+)/(-). Activate the previously selected speed by pulling the lever toward you in the direction of the arrow.

Switching off

If you do not want to use the adaptive cruise control for a long period of time, you can switch it off.

The indicator light and the set speed will turn off.

WARNING

Tips

Audi adaptive cruise control
General information Applies to: vehicles with Audi adaptive cruise control Depending on vehicle equipment, Audi adaptive cruise control may consist of the following functions: Within the limits of the ...

Predictive control
Applies to: vehicles with Audi adaptive cruise control and efficiency assist With predictive control, efficiency assist adapts the set speed in adaptive cruise control (1), fig. 108 based on detected ...

Other materials:

Clock Spring Inspection [Two Step Deployment Control System]
1. Disconnect the negative battery cable and wait for 1 min or more.. 2. Remove the driver?side air bag module.. 3. Remove the steering wheel.. 4. Remove the column cover.. 5. Remove the clock spring.. 6. Verify that the continuity is as indicated in the table. If not as indicated ...

Front Stabilizer Removal/Installation
CAUTION: Performing the following procedures without first removing the front ABS wheel-speed sensor may possibly cause an open circuit in the wiring harness if it is pulled by mistake. Before performing the following procedures, disconnect the front ABS wheel-speed sensor wiring ...

Power windows
Opening and closing the windows Fig. 39 Driver's door: power window switch Power window switches: Left front door Right front door Left rear door Right rear door Opening and closing the windows The driver can control all power windows. All power window switches are equipped with a twostage fu ...

© 2016-2022 Copyright www.mcx5.org