Chevrolet Spark manuals

Audi A4 (B9) 2016-2022 Owner's Manual: Jump starting

Preparation

You should only perform the steps that follow if you have the necessary tools and technical expertise.

If the engine does not start because the vehicle battery is drained, you can jump start your vehicle using another vehicle. Jump start cables are needed to do this.

Both vehicle batteries must have 12 V nominal voltage. The voltage capacity (Ah) of the vehicle battery that is giving power must not be less than the capacity of the drained vehicle battery.

Jump start cable

Only use a jump start cable with a large enough diameter. Note the manufacturer's specifications.

Only use a jump start cable with insulated terminal clamps.

Positive cable - usually red.

Negative cable - usually black.

WARNING

Note

Jump start cables can cause considerable damage to the vehicle electrical system if they are connected incorrectly.

Tips

Jump starting

Both jump start cables must be connected in the correct order.

Emergency assistance
Fig. 178 Engine compartment: connectors for jump start cables or a charger

Emergency assistance
Fig. 179 Engine compartment: connectors for jump start cables or a charger

The jump start cable connections are located in the engine compartment.

Follow the information about the vehicle battery.

Connecting the positive cable (red) to the positive terminal

  1. Attach one end of the positive cable (red) to the jump-start pin (1) > fig. 179 on your vehicle.
  2.  Attach the other end of the positive cable (red) to the positive terminal (2) on the power source.

Connecting the negative cable (black) to the negative terminal

  1. Attach one end of the negative cable (black) to the negative terminal (3) on the power source.
  2. Attach the other end of the negative cable (black) to the jump-start pin (4) on the vehicle.

Starting the engine

WARNING

Note

Please note that the connecting process previously described for the jump start cables is intended for when your vehicle is being jump started.

Tips

Make sure that the connected jump start cables have sufficient contact with metal.

Finishing
Reinstall any covers on the wheel bolts that were removed. Store the vehicle tool kit in its designated place. If the removed wheel does not fit in the spare wheel well, store it securely in th ...

Towing
General information You should only perform the steps that follow if you have the necessary tools and technical expertise. Towing requires a certain amount of practice. Audi recommends contacting a t ...

Other materials:

Cup holders
Applies to: vehicles with cup holders Fig. 75 Rear center armrest*: cup holders Depending on vehicle equipment, your vehicle may have cup holders in the front center console and in the rear center armrest. Cup holders in the rear center armrest* Fold the center armrest* downward. To open the cu ...

Low Fuel Warning Light
Purpose The low fuel warning light warns the driver that the remaining fuel level is low. Function The instrument cluster calculates the fuel quantity based on the following CAN signals, and if a remaining fuel amount of approx. 10 L {2.6 US gal, 2.2 Imp gal} (fuel gauge ...

Front Fog Light Removal/Installation
1. Disconnect the negative battery cable.. 2. Remove the screws and bolt. 3. Pull up the front under cover No.1 and remove the mudguard screw shown in the figure. 4. Disconnect the connector. 5. While pressing the clip tab in the direction of the arrow (1) shown in the figure ...

© 2016-2022 Copyright www.mcx5.org