Chevrolet Spark manuals

Audi A4 (B9) 2016-2022 Owner's Manual: Introduction

Applies to: vehicles with telephone

You can operate various telephone functions easily through the MMI in your vehicle.

Depending on the country and the vehicle equipment, the following options may be available:

WARNING

Note

Read the information about Audi connect, and be sure to note the connectivity costs section.

Tips

Setup

Connecting a mobile phone via Bluetooth

Applies to: vehicles with telephone

Requirement: the vehicle must be stationary and the ignition must be switched on. The Bluetooth settings must be open on your mobile device during the connection setup. The mobile device to be connected must not be actively connected to any other Bluetooth device. The MMI must only be connected to one mobile device.

A PIN for a secure Bluetooth connection will be generated.

After connecting successfully

The cell phone contacts are automatically loaded in the MMI. This process can take several minutes, depending on the number of contacts.

Depending on your cell phone and the connection type, you can use the following functions:

Using the hands-free system

Requirement: your cell phone must be connected to the MMI via a Bluetooth Hands Free Profile (Bluetooth HFP).

You can use the hands-free system. You can make calls using the antenna on your mobile device.

Tips

Using two telephones

Applies to: vehicles with telephone, and Audi phone box

You can connect two mobile phones to the MMI at the same time using the Bluetooth HFP, for example a business phone and a private phone. You can be reached in your vehicle through both mobile phones.

Applies to: mobile devices with Bluetooth Message Access Profile (MAP): You can send and receive messages with both mobile devices.

Connecting another mobile device

Requirement: a mobile device must be connected to the MMI. The vehicle must be stationary and the ignition must be switched on. The Bluetooth settings must be open on your mobile device during the connection setup. The mobile device to be connected must not be actively connected to any other Bluetooth device.

A PIN for a secure Bluetooth connection will be generated.

Switching between two mobile devices

Requirement: phone 1 and phone 2 must be connected to the MMI.

Note

Read the information about Audi connect, and be sure to note the connectivity costs section.

Disconnecting a mobile device

Applies to: vehicles with telephone

Telephone
...

Using the Audi phone box
General information Applies to: vehicles with Audi phone box Fig. 135 Front center console: Audi phone box with connections Depending on vehicle equipment, you may be able to use the following functi ...

Other materials:

Drive By Wire Control
Outline Calculates the optimum target throttle valve opening angle at all engine speeds and controls the throttle valve actuator. The drive-by-wire control is composed of the idle air control, accelerator control, traction control, excess engine speed control, overspeed control, ...

Steps for Determining the Correct Load Limit
Steps for Determining Correct Load Limit- (1) Locate the statement “The combined weight of occupants and cargo should never exceed XXX kg or XXX lbs” on your vehicle's placard. (2) Determine the combined weight of the driver and passengers that will be riding in your vehicle. (3) Subt ...

Clutch Release Cylinder Removal/Installation [C66 M R]
CAUTION: Do not allow clutch fluid to get on a painted surface. Clutch fluid contains properties which can dissolve the paint. If clutch fluid gets on a painted surface, wash it off with water immediately and wipe the area off completely. 1. Remove the front under cover No.2.. ...

© 2016-2022 Copyright www.mcx5.org