Chevrolet Spark manuals

Audi A4 (B9) 2016-2022 Owner's Manual: Gears and driving programs

When driving
Fig. 95 Center console: selector lever

The automatic transmission shifts automatically depending on the selected gear and the current driving style. When driving with a moderate driving style, upshifting early and downshifting late will help to improve fuel economy. When driving with a sporty driving style, the transmission permits higher RPMs.

The gears are displayed next to the selector lever.

Selecting a gear

Requirement: the ignition must be switched on.

"N" (Neutral) position

In the "N" selector lever position, power is not transmitted to the driving wheels. Use the "N" selector lever in a car wash (with conveyor belts), for example.

If you unintentionally select "N" while driving (faster than 1 mph (2 km/h) ), you can also select "D" again without pressing the brake pedal.

For safety reasons, the vehicle cannot be locked when the "N" position is engaged.

"P" (Park) selector lever position

Requirement: the ignition must be switched on.

The parking lock secures the vehicle from rolling when the "P" selector lever position is selected.

The parking lock is a mechanical locking mechanism in the transmission.

"P" engages automatically if you switch the engine off while the "D" or "R" gear is selected. If you switch the engine off in "N", "P" will engage automatically after approximately 30 minutes.

If you want to switch from "P" to "D" or "R", the engine must be running.

If you cannot shift out of "P", for example because the vehicle has no power, you may need to use the emergency release for the parking lock.

Selecting a driving program

Various driving programs can be selected when in the "D" gear. The programs influence when the transmission shifts and how the accelerator pedal responds.

The selected driving program is displayed in the instrument cluster.

If you select the dynamic mode in Audi drive select*, the "S" driving program will be activated.

When the ignition is switched off, the driving program may be reset to "D".

To switch between the current driving program and "S", push the selector lever toward the rear.

The S driving program might not be available in the Audi drive select* offroad mode.



If you shift back and forth between "D" and "R" within one second, you do not need to press the brake pedal. This makes it possible to "rock" if it is stuck, for example.

When driving
Starting to drive, stopping, and parking Starting from a stop Press and hold the brake pedal. Start the engine. Select "D" or "R". Release the parking brake. Release the brake pedal. The vehicle ...

Manual shifting
Fig. 96 Center console: shifting manually with the selector lever Fig. 97 Steering wheel: shift paddles* You can shift the gears manually when in "D" mode. The transmission is in tiptronic mode and ...

Other materials:

Passenger Compartment Temperature Sensor Removal/Installation [Full Auto Air Conditioner]
1. Disconnect the negative battery cable.. 2. Remove the following parts: a. Front scuff plate (driver-side). b. Front side trim (driver-side). c. Switch panel. d. Decoration panel. e. Shift lever knob (MTX). f. Front console box. g. Shift panel. h. Upper panel. i. Rear console. ...

Audio Unit Removal/Installation
Removal 1. Disconnect the negative battery cable. 2. Remove the decoration panel.. 3. Remove the bolt. 4. Remove the screws. NOTE: When removing the audio unit, the audio unit could interfere with the climate control unit and scratch the climate control unit. Perform the serv ...

PID/Data Monitor Inspection [Start Stop Unit]
1. Connect the M-MDS to the DLC?2. 2. After the vehicle is identified, select the following items from the initialization screen of the M-MDS. Select “DataLogger”. Select “Modules”. Select “SSU”. 3. Select the applicable PID from the PID table. 4. Veri ...

© 2016-2022 Copyright