Chevrolet Spark manuals

Audi A4 (B9) 2016-2022 Owner's Manual: During a phone call

Applies to: vehicles with telephone

Depending on your mobile device and the type of connection, the following options may be available during a call:

Sending a tone sequence

Press Numbers. You can enter tone sequences (DTMF) and send them to the other party on the call.

Hold

Puts the current call on hold. To resume the call, press Resume.

Answering an incoming call

One of these options will be available, depending on the mobile phone service provider:

Declining an incoming call

If you select Decline, the incoming call will be declined.

Conference

Requirement: two phone calls must be in progress.

Depending on your mobile phone service provider, you can add a call on hold and up to five active callers to a conference call.

Swap call

Requirement: two phone calls must be in progress.

You can alternate between two phone calls.

Additional call options

Press More.

Depending on the mobile device being used and the type of connection, the following options may be available:

Transfer call to mobile device

Transfer the current call to your mobile device or Bluetooth headset*.

Switch to hands-free

Transfer the current call from your mobile device to the MMI.

Add call

You can start a new call. The current call will be put on hold.

Remove conference member

You can remove conference call members individually when a conference call is active.

Microph. input

You can adjust the input level of the microphone using the slider.

Tips

The call waiting function must be activated in your mobile device to be alerted about an incoming call during an active call.

Making an emergency call

Applies to: vehicles with telephone

Requirement: a mobile device must be connected to the MMI.

WARNING

Managing favorites
Applies to: vehicles with telephone You can store contacts for all connected mobile devices as shortcuts in the favorites list. Selecting favorites using the MMI Applies to: MMI: Select on the home ...

Settings
Telephone settings Applies to: vehicles with telephone Applies to: MMI: Select on the home screen: PHONE > . The following options may be possible, depending on your mobile device: Decline wi ...

Other materials:

Turbine/Input Shaft Speed Sensor, Output Shaft Speed Sensor [Fw6 A EL, Fw6 Ax EL]
Purpose/Function The turbine/input shaft speed sensor detects the rotation speed of the input shaft (low clutch drum). The output shaft speed sensor detects the rotation speed of the output shaft (primary gear). The turbine/input shaft speed sensor and output shaft speed ...

Front Door Latch And Lock Actuator Removal/Installation
1. Perform the front door glass preparation.. 2. Disconnect the negative battery cable.. 3. Remove the following parts: a. Inner garnish. b. Front door trim. c. Inner handle. d. Front door glass. e. Front door module panel. f. Front door key cylinder. 4. Remove the door lock knob c ...

Antenna Feeder No.2 Inspection
1. Disconnect the negative battery cable.. 2. Remove the following parts: a. A-pillar trim (RH). b. Trunk board. c. Trunk end trim (RH). d. Rear scuff plate (RH). e. Trunk side trim (RH). 3. Disconnect antenna feeder No.1. 4. Disconnect antenna feeder No.3. 5. Verify that t ...

© 2016-2022 Copyright www.mcx5.org