Chevrolet Spark manuals

Audi A4 (B9) 2016-2022 Owner's Manual: Distance warning

Description

Applies to: vehicles with distance warning

Driver assistance
Applies to: vehicles with adaptive cruise control:
Fig. 117 Instrument cluster: display of the current distance

Driver assistance
Applies to: vehicles with Audi adaptive cruise control
Fig. 118 Instrument cluster: distance warning

General information

At speeds above approximately 40 mph (65 km/h), this function measures the distance to the vehicle ahead as time. If the distance falls below the warning threshold and remains there, the system will warn you of the hazard with the indicator light.

Image in the Driver assistance display

Applies to: vehicles with Audi adaptive cruise control

The display only appears if the Driver assistance display is selected in the trip computer and the adaptive cruise control is not actively controlling the vehicle.

  1. Detected vehicle driving ahead
  2. Use the markings to help you estimate the distance to an obstacle. Each marking represents approximately one second.
  3. Set warning threshold. Depending on the settings, the display will be colored in from the bottom to the top.
  4. The actual distance is smaller than the set distance and you will be informed about the danger.

Adjusting the distance warning

You can turn the distance warning on or off in the MMI, or adjust it to your preference. The settings depend on the vehicle equipment.

Possible settings:

Messages

If or is displayed when there is a malfunction, the distance warning functions may be unavailable or may be limited.

A message that indicates the cause and possible solution may appear with some displays. The weather conditions may be too poor or a sensor may be covered. Clean the area in front of the sensors and try to turn the system on again later.

If the malfunction remains, drive to an authorized Audi dealer or authorized Audi Service Facility immediately to have the malfunction corrected.

WARNING

Observe the safety precautions and note the limits of the assist systems, sensors, and cameras.

Tips

Traffic jam assist
Description Applies to: vehicles with traffic jam assist Fig. 116 Turn signal lever: button for traffic jam assist and Audi active lane assist Traffic jam assist supports the driver when driving in ...

Audi active lane assist/lane departure warning
General information Applies to: vehicles with Audi active lane assist The Audi active lane assist/lane departure warning (called only Audi active lane assist in the vehicle displays and in the informa ...

Other materials:

Outer Mirror Garnish Removal/Installation
1. Disconnect the negative battery cable.. 2. Remove the outer mirror glass.. 3. Insert a tape-wrapped flathead screwdriver into the upper outer mirror garnish and remove tab A, B, C, D in the direction of arrow (1). 4. Insert a tape-wrapped flathead screwdriver into the upper outer mirr ...

Power Window Motor Removal/Installation
Front Power Window Motor 1. Fully lower the front door glass. 2. Disconnect the negative battery cable.. 3. Remove the inner garnish.. 4. Remove the front door trim.. 5. Disconnect the front power window motor connector. 6. Remove bolt A. 7. Remove bolt B. 8. Remove bolt C. 9. R ...

Start Stop Unit Configuration (Using As Built Data)
NOTE: If the configuration is performed using As-Built data, the set value of the personalization function is reset to the initial value (condition when shipped from factory). Verify the set value with the customer and perform the personalization function setting after performing th ...

© 2016-2022 Copyright www.mcx5.org