Chevrolet Spark manuals

Audi A4 (B9) 2016-2022 Owner's Manual: Adjusting adaptive cruise control

Applies to: vehicles with Audi adaptive cruise control

You can adjust the system individually. The settings depend on the vehicle equipment.

Possible settings:

Applies to: vehicles without Audi drive select

Driving program - Depending on the selected driving program and distance, the vehicle handling will be adjusted from Sport to Comfort.

Applies to: vehicles with Audi drive select

Vehicle handling will be adjusted based on the set distance and the selected Audi drive select mode.

Store last distance - The last distance that was set will be stored after the ignition is switched off. If the distance is not stored, distance (time distance of approximately 1.8 seconds) is automatically preset every time the ignition is switched on.

Predictive control > Set speed limit - adaptation to speed limits can be switched On or Off. Regulation With tolerance can also be selected, if desired.

In this scenario, you may fall below or exceed the set speed in favor of increased efficiency.

Predictive control > Adjustment to curves along route - Adjustment based on the road ahead can be adjusted. The setting influences vehicle handling with predictive control, for example the speed for driving through curves.

Tips

Certain settings are automatically stored and assigned to the remote control key being used.

Messages

Applies to: vehicles with Audi adaptive cruise control

If or is displayed when there is a malfunction, the adaptive cruise control or traffic jam assist functions may be unavailable or may be limited.

A message that indicates the cause and possible solution may appear with some displays. The weather conditions may be too poor or a sensor may be covered. Clean the area in front of the sensors and try to turn on the systems again Later.

If the malfunction remains, drive to an authorized Audi dealer or authorized Audi Service Facility immediately to have the malfunction corrected.

The following messages may appear depending on the vehicle equipment:

ACC off: manual control!

This message appears if the vehicle rolls back when starting on a slight incline, even though the systems are active. Press the brake pedal to prevent the vehicle from rolling or starting to move.

Setting the distance
Applies to: vehicles with Audi adaptive cruise control Fig. 112 Operating lever: setting the distance When approaching a vehicle driving ahead, the adaptive cruise control system brakes to match that ...

Traffic jam assist
Description Applies to: vehicles with traffic jam assist Fig. 116 Turn signal lever: button for traffic jam assist and Audi active lane assist Traffic jam assist supports the driver when driving in ...

Other materials:

Accessory Sockets
Only use genuine Mazda accessories or the equivalent requiring no greater than 120 W (DC 12 V, 10 A). Front The ignition must be switched to ACC or ON. Center, Rear The accessory sockets can be used regardless of whether the ignition is on or off. CAUTION ●To prevent accessory ...

Awd Solenoid Inspection
1. Disconnect the negative battery cable. 2. Disconnect the AWD solenoid connector. 3. Measure resistance between AWD solenoid connector terminals A and B. If the resistance is not within the specification, replace the coupling unit. AWD solenoid resistance 2.2—2.7 oh ...

Rear Sash Molding Installation
WARNING: Using a utility knife with bare hands can cause injury. Always wear gloves when using a utility knife. NOTE: Double-sided adhesive tape has already been attached to the new rear sash molding. 1. When installing a new rear sash molding, follow the procedure ...

© 2016-2022 Copyright www.mcx5.org