Mazda CX-5 Service & Repair Manual: Speaker [With Bose®]
Purpose
-
Converts the audio signal from the audio unit to sound.
-
High quality sound is provided for the driver and passengers.
Function
-
Full-range speakers, which can output wide-range sound from low to high frequency, have been adopted.
-
A better sound effect and clear sound have been realized by using tweeters (speaker for upper register sound range) which differ the range of the output sound and woofer (speaker for lower register sound range).
Specification
|
Item |
Front door speaker |
Rear speaker |
Tweeter |
Front center speaker |
D-pillar speaker |
|
|
Rated impedance |
(ohm) |
1.25 |
3.7 |
3.24 — 3.96 |
3.24 — 3.96 |
3.24 — 3.96 |
|
Size |
(mm {in}) |
225 {8.86} |
133 {5.25} |
80 {3.1} |
80 {3.1} |
80 {3.1} |
Construction
-
A cone-shaped dynamic speaker has been adopted for each speaker.
-
Pulp for the cone material and a neodymium magnet have been adopted.
-
A better sound effect is achieved by the use of speakers which differ the range of the output sound.
-
Front door speaker (speaker for deep bass sound range)
-
Rear door speaker (speaker for all sound ranges)
-
Tweeter (speaker for medium-to-high-sound range)
-
Front center speaker (speaker for medium-to-high-sound range)
-
D-pillar speaker (speaker for medium-to-high-sound range)
Operation
-
For the speaker operation, refer to the SPEAKER [WITHOUT Bose®].
Fail-safe
-
Function not equipped.
Speaker Grille Removal/Installation
Center Speaker Grille
1. Insert a tape-wrapped flathead screwdriver into shown in the figure and remove
hooks A in the direction of arrow (1).
2. Take the shaded area shown in the figure, and ...
Speaker [Without Bose®]
Purpose
Converts the audio signal from the audio unit to sound.
Function
Full-range speakers, which can output wide-range sound from low to high frequency,
have been adopted.
...
Other materials:
Antenna Feeder No.2 Inspection
1. Disconnect the negative battery cable..
2. Remove the following parts:
a. A-pillar trim (RH).
b. Trunk board.
c. Trunk end trim (RH).
d. Rear scuff plate (RH).
e. Trunk side trim (RH).
3. Disconnect antenna feeder No.1.
4. Disconnect antenna feeder No.3.
5. Verify that t ...
Passenger Compartment Temperature Sensor Removal/Installation [Full Auto Air
Conditioner]
1. Disconnect the negative battery cable..
2. Remove the following parts:
a. Front scuff plate (driver-side).
b. Front side trim (driver-side).
c. Switch panel.
d. Decoration panel.
e. Shift lever knob (MTX).
f. Front console box.
g. Shift panel.
h. Upper panel.
i. Rear console. ...
Turn and Lane-Change Signals
NOTE
• If an indicator light stays on without
flashing or if it flashes abnormally, one of the turn signal bulbs may be burned
out.
• A personalized function is available to change
the turn indicator sound volume.
Refer to Personalization Features on .
Turn Signals
Move the signal lev ...
