Chevrolet Spark manuals

Mazda CX-5 Service & Repair Manual: Speaker Grille Removal/Installation

Mazda CX-5 Service & Repair Manual / Accessories / Electronics / Entertainment / Speaker Grille Removal/Installation

Center Speaker Grille

1. Insert a tape-wrapped flathead screwdriver into shown in the figure and remove hooks A in the direction of arrow (1).


2. Take the shaded area shown in the figure, and remove the center speaker grille in the direction of arrow (2) while detaching hooks B.


3. Install in the reverse order of removal.

Side Speaker Grille

1. Insert a tape-wrapped flathead screwdriver into the service hole and remove hooks A in the direction of arrow (1).


2. Pull the side speaker grille in the direction of the arrow (2), and remove the side speaker grille while detaching hooks B.


3. Install in the reverse order of removal.

Sirius Satellite Radio Unit Removal/Installation
CAUTION: The audio unit communicates with the SIRIUS satellite radio unit and records the presence/non-presence of the SIRIUS satellite radio unit when the ignition is switched to ACC or ...

Speaker [With Bose®]
Purpose Converts the audio signal from the audio unit to sound. High quality sound is provided for the driver and passengers. Function Full-range speakers, which can output ...

Other materials:

Oil Seal (Differential) Replacement [Fw6 A EL, Fw6 Ax EL]
Transaxle Case Side 1. Remove the front under cover No.2.. 2. Drain the ATF.. 3. Disconnect the drive shaft (LH) from the transaxle.. CAUTION: The oil seal is easily damaged by the sharp edges of the drive shaft splines. Do not let the splines contact the oil seal. 4. Remove ...

Rear Wiper Motor Inspection
1. Disconnect the negative battery cable.. 2. Open the liftgate. 3. Remove the following parts: a. Rear wiper arm and blade. b. Liftgate upper trim. c. Liftgate side trim. d. Liftgate recess. e. Liftgate lower trim. 4. Remove the rear wiper motor connector. Rear Wiper Motor Ope ...

Front Scuff Plate Removal/Installation
1. Take the shaded area shown in the figure, detach tab A while pulling the front scuff plate in the direction of the arrow (1) shown in the figure, then detach the hook B, clip C, and pin D while pulling in the direction of the arrow (2). 2. Take the shaded area shown in the figure, detach ta ...

© 2016-2025 Copyright www.mcx5.org