Mazda CX-5 Service & Repair Manual: Push Button Start Inspection

Mazda CX-5 Service & Repair Manual / Vehicle General / Push Button Start Inspection

1. Remove the push button start..

2. Verify that the continuity between the push button start terminals is as indicated in the table.

If the continuity can be verified as indicated in the table, go to the next step.
If not as indicated in the table, replace the push button start..

3. Apply battery positive voltage and connect the ground to the push button start terminals and verify that the LED illuminates as indicated in the table.

If the LED does not illuminate as indicated in the table, replace the push button start..

Pre Delivery Inspection

Pre?Delivery Inspection Table Exterior INSPECT and ADJUST, if necessary, the following items to specification: ?Glass, exterior bright metal and paint for damage ?Wheel lug nuts ?All weathe ...

Push Button Start Removal/Installation

1. Disconnect the negative battery cable.. 2. Remove the meter hood.. 3. While pressing the push button start tab in the direction of the arrow (1) shown in the figure, push out the push button ...

Other materials:

Electrical Fan Control [Skyactiv G 2.0]
Outline Through cooling of the radiator and condenser by operation of the cooling fan according to vehicle conditions, engine reliability and cooling performance have been improved. Block Diagram Operation The PCM determines the demand airflow volume by the following c ...

Rear End Panel Installation [Panel Replacement]
Symbol Mark Installation Procedure 1. When installing new parts, measure and adjust the body as necessary to conform with standard dimensions. 2. Drill holes for the plug welding before installing the new parts. 3. After temporarily installing new parts, make sure the related parts fit p ...

Floor Side Panel Installation [Panel Replacement]
Symbol Mark Installation Procedure 1. When installing new parts, measure and adjust the body as necessary to conform with standard dimensions. 2. Drill holes for the plug welding before installing the new parts. 3. After temporarily installing new parts, make sure the related parts fit p ...