1. Disconnect the negative battery cable..
2. Remove the front over fender..
3. Remove the mudguard (RH)..
4. Disconnect the rear washer hose A from the washer motor.
5. Remove the rear washer hose A from the washer tank hook.
6. Remove the rear washer hose A from clips A and B.
7. Disconnect the rear washer hose A from the joint pipe A and remove it.
8. Disconnect the rear washer hose B from the joint pipe A.
9. Remove the sunroof seaming welt. (with sunroof).
10. Remove the A pillar trim..
11. Disconnect the rear washer hose B from the joint pipe B and remove it.
12. Disconnect the rear washer hose C from the joint pipe B.
13. Remove the following parts:
a. Map light.
b. Sunvisor.
c. Front scuff plate.
d. Rear scuff plate.
e. B-pillar lower trim.
f. Front seat belt adjusting cover.
g. Front seat belt upper anchor installation bolt.
h. B-pillar upper trim.
i. Assist handle.
j. Trunk board.
k. Trunk end trim.
l. Trunk side trim.
m. D-pillar trim.
n. C-pillar trim.
o. Headliner.
14. Remove the tape and clips shown in the figure.
Without sunroof
With sunroof
15. Disconnect the rear washer hose C from the joint pipe C and remove it.
16. Disconnect the rear washer hose D from the joint pipe C.
17. Remove the liftgate upper trim..
18. Partially peel the liftgate grommet in the direction of arrow (1) shown in the figure, and remove the liftgate grommet from the liftgate grommet inner.
19. Using a tape-wrapped precision flathead screwdriver, press the liftgate grommet inner tabs in the directions of arrows (2) and (3) shown in the figure and remove each liftgate grommet inner from the liftgate and vehicle side in the direction of arrow (4).
20. Disconnect the rear washer hose D from the rear washer nozzle and remove it.
21. Install in the reverse order of removal.
Automatic Transaxle Outline [Fw6 A EL, Fw6 Ax EL]
Outline
Contribution to low fuel economy
Wide TCC range
Clutch/brake resistance reduction
Realized direct feel and quick shifting
Oil passage resistance reduction and improved clutch/brake response
b ...
Awd Solenoid Inspection
1. Disconnect the negative battery cable.
2. Disconnect the AWD solenoid connector.
3. Measure resistance between AWD solenoid connector terminals A and B.
If the resistance is not within the specification, replace the coupling unit.
AWD solenoid resistance
2.2—2.7 oh ...
Windshield Wiper System
Outline
Equipped with continuous (low/high), auto-stop, one-touch wiper, intermittent
wiper (without auto wiper system), auto wiper (with auto wiper system), and
synchronized washer and wiper operation.
The front body control module (FBCM) performs windshield wiper and washer
...