1. Switch the ignition ON (engine off or on).
2. Open the driver's door.
3. Switch the ignition OFF.
4. Disconnect the negative battery cable..
5. Remove the column cover..
6. Rotate the steering wheel in the direction of the arrow shown in the figure to the angle where the service hole is visible.
7. Insert a tape-wrapped flathead screwdriver into the service hole in the position shown in the figure.
8. While pressing the wiper and washer switch tab in the direction of the arrow (1) shown in the figure using a flathead screwdriver, pull out the wiper and washer switch in the direction of the arrow (2) shown in the figure to detach the wiper and washer switch tab and the start stop unit.
9. Remove the wiper and washer switch from the start stop unit.
10. Install in the reverse order of removal.
Powertrain System [C66 M R]
Purpose, Function
The powertrain mechanism changes the gear combination by engaging or releasing
the clutch hub and gear, and changes the power transmission route. Because of
the change in the power transmission route, the drive force (speed, torque,
rotation direction) input from th ...
Side Turn Light Removal/Installation
1. Disconnect the negative battery cable..
2. Remove the following parts:
a. Outer mirror glass.
b. Upper outer mirror garnish.
3. Remove the screws.
4. Disconnect the connector.
5. Remove the side turn light.
6. Install in the reverse order of removal. ...
Airflow Volume Control [Full Auto Air Conditioner]
Purpose
The airflow volume control changes the airflow volume according to the vehicle
environment.
Function
The airflow volume control changes the operation of the blower motor according
to the operations of the airflow volume control dial or temperature control
dial an ...