Mazda CX-5 Service & Repair Manual: Tie Rod End Replacement
1. Remove the snap pin.
2. Loosen the tie-rod end locknut.
3. Detach the tie-rod end from the steering knuckle using the SST
.
4. Remove the tie-rod end locknut.
5. Place alignment marks as shown in the figure for proper installation.
6. Remove the tie-rod end.
7. Align the alignment marks made before removing the tie-rod end, and then install a new tie-rod end to the tie rod.
-
If there are no alignment marks, go to the following procedure.
8. Adjust dimension A shown in the figure to the standard, and assemble.
-
Standard Dimension A
-
10.1—23.1 mm {0.398—0.909 in}
9. Install the tie-rod end to the steering knuckle.
10. Install a new snap pin.
11. After installation, inspect the front wheel alignment and adjust it if necessary..
Tie Rod End Inspection
1. Inspect the tie-rod end for damage and the boot for cracks.
If there is any malfunction, replace the tie-rod end.
2. Inspect for excessive play.
If there is any malfunction, ...
Tie Rod Inspection
1. Inspect for bending and damage.
If there is any malfunction, replace the tie rod.
2. Inspect for excessive play.
If there is any malfunction, replace the tie rod.
3. Swi ...
Other materials:
Windshield Wiper System
Outline
Equipped with continuous (low/high), auto-stop, one-touch wiper, intermittent
wiper (without auto wiper system), auto wiper (with auto wiper system), and
synchronized washer and wiper operation.
The front body control module (FBCM) performs windshield wiper and washer
...
Engine Coolant
Inspecting Coolant Level
WARNING
Do not use a match or live flame in the engine compartment. DO NOT ADD COOLANT
WHEN THE ENGINE IS HOT:
A hot engine is dangerous. If the engine has been running, parts of the engine
compartment can become very hot. You could be burned.
Carefully inspect the e ...
Fuel Tank Pressure Sensor
Purpose/Function
The fuel tank pressure sensor detects the fuel tank pressure.
Fuel tank pressure sensor is only used for OBD.
Construction
The fuel tank pressure sensor is equipped to the charcoal canister.
A piezoelectric-type sensor has been adopted.
...
