Mazda CX-5 Service & Repair Manual: Tcs Off Switch, Tcs Off Indicator Light
Purpose/Function
-
The TCS OFF switch, located on the dashboard, allows for optionally enabling/disabling the TCS control at driver discretion.
-
The TCS OFF indicator light, built into the instrument cluster, informs the driver that TCS control has been disabled by operation of the TCS OFF switch.
Operation
-
When the DSC system and CAN lines are functionally normally, the TCS OFF indicator light illuminates for approx. 3.0 s when the ignition is switched to ON to check the light function.
-
When the TCS OFF switch is pressed to disable TCS control, the TCS OFF indicator light illuminates.
NOTE:
-
To inhibit the TCS control, continue to press the TCS OFF switch until the TCS OFF indicator light illuminates.
-
The TCS OFF indicator light illumination and TCS/DSC/roll over mitigation (ROM) control conditions while operating the TCS OFF switch are as indicated in the table.
|
TCS OFF indicator light illumination conditions |
TCS control conditions |
DSC control conditions |
Roll over mitigation (ROM) control conditions |
||
|
Brake control |
Engine control |
||||
|
TCS ON |
Not illuminated |
Permitted |
Permitted |
Permitted |
Permitted |
|
TCS OFF |
Illuminated |
Permitted |
Inhibited |
Permitted |
Permitted |
Fail-safe
|
DTC No. |
Fail-safe function |
|
C0089:64 |
|
Shift Position Indicator Light [Fw6 A EL, Fw6 Ax EL]
Purpose/Function
The shift position indicator light indicates the selector lever position.
Construction
The shift position indicator light is built into the instrument cluster.
...
Tcs/DSC Indicator Light
Purpose/Function
The TCS/DSC indicator light, built into the instrument cluster, informs the
driver of the following vehicle conditions.
TCS is operating. (Drive wheel is slippi ...
Other materials:
Main Fuse Removal/Installation
1. Disconnect the negative battery cable..
2. Insert a tape-wrapped flathead screwdriver into the service hole in the position
shown in the figure.
3. Move the flathead screwdriver in the direction of the arrow (1) shown in the
figure, pull up the main fuse cover in the direction of the ...
Rear Side Marker Light Bulb Removal/Installation
1. Disconnect the negative battery cable..
2. Insert a tape-wrapped flathead screwdriver into the service hole in the position
shown in the figure.
3. Move the flathead screwdriver in the direction of the arrow (1) shown in the
figure, pull out the service hole cover, and detach the serv ...
Air Bag System Warning Alarm [Standard Deployment Control System]
Purpose
The air bag system warning alarm notifies the driver that a malfunction occurred
in the air bag system instead of the air bag system warning light.
Function
If a malfunction occurs in the air bag system while the air bag system warning
light cannot illuminate, the a ...
