1. Remove the rear stabilizer control link..
2. Inspect for bending or damage. If there is any malfunction, replace the rear stabilizer control link.
3. Rotate the ball joint stud 10 times
and shake it side to side 10 times
.
4. Measure the ball-joint rotational torque using an Allen wrench and a torque wrench.
0.8—3.5 N·m {8.2—35 kgf·cm, 7.1—30 in·lbf}
If not within the specification, replace the rear stabilizer control link.
Even when within the specification, if there is excessive play in the ball joint, replace the rear stabilizer control link.
Front Combination Light Removal/Installation
WARNING:
Incorrect servicing of the discharge headlights could result in electrical
shock. Before servicing the discharge headlights, always refer to the service
warnings..
NOTE:
Fogging or condensation on the inside of the front combination lights may
occur due to a n ...
Oil Pan
Purpose, Function
The engine oil required for lubrication in the engine accumulates in the
oil pan.
Construction
The oil pan is installed on the lower part of the cylinder block.
Silicone sealant with excellent sealing has been adopted for the oil pan
gask ...
Fuel Line Pressure Inspection
WARNING:
Fuel line spills and leakage from the pressurized fuel system are dangerous.
Fuel can ignite and cause serious injury or death and damage. To prevent this,
complete the following inspection with the engine stopped.
Fuel is very flammable liquid. If fuel spills or leaks ...